Ezigrade (version 2)

Grid

 
The grid routines are accessed via the grid controls along the right hand edge of the screen. If you can't see the grid; press the reset key and a grid is displayed in the middle of the current view. The next step is to edit the grid details to satisfy our requirements.
 
First select the grid. Do this by left clicking the mouse while having the cursor lay along one of the grid axes. A number of handles/drag points are enabled. They are highlighted as green squares. One of them is red. To change the current position of the grid click in the lower left square and while keeping the left mouse pressed; simply move the gris. It will follow the cursor. To change the extents left click in the squares at the end of the grid. To change the cell size click in either of the squares 1 cell width from the origin. To change the rotation click on red and move – grid rotates with the cursor.
 
It is highly likely that you would prefer even numbers for grid position, length, grid size etc. If so simply fill in the appropriate values in the grid dialog bar and press the apply key. Using a combination of these two methods should allow one to easily adjust the grid to fit.
 
The diagram below shows the grid once selected and the drag points. Once finished simply press the “esc” key to unselect the grid.
 
 
 

Made with help of DrExplain

TODO: Change the footer's content in Project Settings : HTML (CHM) Export : Setup HTML Template and Layout